Replacing Batteries in Tapo Motion, Door/Window and Human Presence Sensors

When a Tapo sensor battery runs low or runs out, replace it using the instructions for your model below. For Motion Sensors and Door/Window Sensors, keep the replacement battery level with its positive side facing up, then refit the cover securely.

Tapo Motion Sensor

1. Lift the clip on the back, then use your other hand to turn the cover anticlockwise and take it off.
2. Take out the depleted battery.
3. Place the new battery in the compartment, keeping it level and positive side up.
4. Refit the cover securely.

Tapo Door/Window Sensor

1. Open the cover using the method appropriate to its installation:
   • Not yet installed on a door or window: Lift the clip with a screwdriver while sliding the cover down with your other hand.

     

   • Already installed on a door or window: Push the cover upward to remove it.

     

2. Undo the screw holding the battery in place, then take out the old battery.
3. Fit the replacement battery into the compartment, level and with its positive side facing up.
4. Slide the cover downward to secure it again.

   

Tapo Human Presence Sensor

1. Take off the rear cover.
2. Exchange the old batteries for new batteries (AAA/LR03).

   

For further details about functions and configuration, download your product manual from the Download Center.